, or

The Scart or Euro connector was introduced to enable ease of connection between Audio-Visual equipment, and has been largely successful in providing a compatible and widely accepted standard.
However, it is often necessary to construct custom leads to overcome the limitations of equipment which only has one such connector, or to provide an interface with older sets which have alternative sockets, etc.
To assist with the identification of the signals present and to ease manufacture of such leads, refer to the diagram / table below:

This view of the scart connector is from the inside of the plug. Note: Pin 21 is the shield of the connector!

Pin No Signal 1 Audio O/P Right 3 Audio O/P Left 5 BLUE Video GND 7 BLUE Video 9 GREEN Video GND 11 GREEN Video 13 RED Video GND 15 RED Video 17 Video GND 19 Video O/P 21 Common GND

Pin No Signal 2 Audio I/P Right 4 Audio GND 6 Audio I/P Left 8 Function Switching 10 Data line 2 12 Data line 1 14 Data GND 16 Balnking 18 Blanking GND 20 Video I/P All commonly used pins are marked in bold.

The information contained upon this page is supplied in good faith, and to the best of my knowledge is accurate.
However, I accept no responsibility for damage or injury, however caused, due to the use of this data.